ORIGINAL AND MAX INSTALLATIONWOOD FRAMES AND CANVASES

ORIGINAL Installation

For thinner frames,use the top set of holes on the flanges.

Step 1
Using the screws provided, attach the Beehive Picture Hangers® to the top corners of your frame.

Step 2
Hold your frame up to the wall in the desired position and press against the top of the frame. Apply enough pressure so the small points on the front of the hangers mark your drywall. TIP: For a more noticeable wall mark, GENTLY jiggle the frame corners while pressing. Be sure to exercise care not to scratch your wall.

Step 3
Insert the short end of a support pin into the Beehive Stinger and press into the wall where you made your mark. Be sure to insert at a downward angle so the rectangular plate is parallel to the wall as shown. Repeat for the second support pin.

Step 4
Hang your frame on the support pins. If adjustment is needed, simply lift the frame from the pin(s) and reinsert into another hole in the hanger.

MAX Installation

Step 1
Using the screws provided, attach the Beehive Picture Hangers® to the top corners of your frame. The Max hangers can be attached across the miter joints, helping prevent joint separation on heavy frames (See Tip on left).

Step 2
Hold the frame up to the wall in the desired position and press against the top of the frame. Apply enough pressure so the small points on the front of the hangers mark your drywall. TIP: For a more noticeable wall mark, GENTLY jiggle the frame corners while pressing. Be sure to exercise care not to scratch your wall.

Step 3
Insert the short end of a support pin into the Beehive Stinger and press into the wall where you made your mark. Be sure to insert at a downward angle so the rectangular plate is parallel to the wall as shown. Repeat for the second support pin.

Step 4
Hang your frame on the support pins. If adjustment is needed, simply lift the frame from the pin(s) and reinsert into another hole in the hanger.